Compartible Systems Corporation RISC 2600i Guía de usuario descargar pdf (Pagina 26)

2–Installing Software and Initial Setup

Multi-boot Image for Fibre Channel Adapter Function Configuration Utility

2-4 FC0054609-00 B

The Fast!UTIL Options menu provides the following options:

 Configuration Settings

 Scan Fibre Devices

 Fibre Disk Utility

 Loopback Data Test

 Select Adapter

 Personality

 Exit Fast!UTIL

Configuration Settings

The following topics show and describe the 2600 Series Adapters configuration

settings:

 Adapter Settings

 Selectable Boot Settings

 Restore Default Settings

 Raw NVRAM Data

 Advanced Adapter Settings

Adapter Settings

Table 2-1 describes the adapter settings.

Table 2-1. Adapter Settings

Setting Values Default Description

Host Bus

Adapter

BIOS

Enabled/

Disabled

Disabled Disabling this setting disables the ROM BIOS

on the 2600 Series Adapter, which frees

space in upper memory. If you are booting

from a Fibre Channel disk drive attached to

the 2600 Series Adapter, you must enable

this setting. See “Selectable Boot Settings”

on page 2-5 for details on specifying the boot

device.

Frame Size 512/1024/

2048

2048 This setting specifies the maximum frame

length supported by the 2600 Series Adapter.

Loop Reset

Delay

0–60 sec-

onds

5 seconds After resetting the loop, the firmware refrains

from initiating any loop activity for the number

of seconds specified in this setting.

Adapter

Hard Loop

Enabled/

Disabled

Disabled If the Adapter Hard Loop ID setting is

enabled, the adapter attempts to use the ID

specified in the Hard Loop ID setting.

Hard Loop

0–125 0 If the Adapter Hard Loop ID setting is

enabled, the adapter attempts to use the ID

specified in this setting.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 65 66

Comentarios a estos manuales

Sin comentarios

Compartible Systems Corporation RISC 2600i Guía de usuario Pagina 26

Comentarios a estos manuales